Fujitsu Fi-7030 User Manual

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
139
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 108).
2 From the listing on the left, select [Device Setting].
3 Use the slider to specify the waiting time before the
scanner enters power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].

Fujitsu Fi-7030 Specifications

General

Optical Resolution	600 dpi
ADF Capacity	50 sheets
Interface	USB 2.0
Duplex Scanning	Yes
Scanner Type	ADF (Automatic Document Feeder)
Supported Paper Size	A4, A5, A6, B5, B6, Letter, Legal
Scanning Method	Color
Scan Speed (Color, A4, 200 dpi)	30 ppm / 60 ipm
Power Consumption	Operating: 18 W or less
Scanning Speed	30 ppm / 60 ipm
Daily Duty Cycle	Up to 4, 000 sheets