How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Daily Care
Operational
Settings
Chapter 5 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
71
How to Load
Documents
Scanner
Overview
The Carrier Sheet should be cleaned with either a piece of dry
cloth, a cloth moistened with Cleaner F1/mild detergent, or a
sheet of Cleaning Wipe.
Gently wipe the dirt and dust off the surface and the inside of
the Carrier Sheet.
As you keep using the Carrier Sheet, dirt and dust will
accumulate on the surface and the inside.
Clean it regularly because it may result in scanning errors.
5.4 Cleaning the Carrier Sheet
ATTENTION
Make sure that the Carrier Sheet is not creased.
To avoid deformation and discoloration, never use paint thinner or
any other organic solvents.
Do not use force to rub against the Carrier Sheet because it may be
damaged or deformed.
After cleaning the inside, do not close the Carrier Sheet until it is
completely dry.
The Carrier Sheet should be replaced approximately every 500
scans.
For information on purchasing the Carrier Sheet, contact your
FUJITSU scanner dealer or an authorized FUJITSU scanner service
provider.
To Next Page
Loading...
Need help?
General
