Fujitsu Fi-7030

Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
129
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 108).
2 From the listing on the left, select [Device Setting 2] 
[Dropout color].
3 Select a color to drop out.
Red, Green, Blue: The selected color is dropped out.
None: No color is dropped out.
Number of Paper Feeding Retries
Configure this setting to change the number of feeding retries
when a pick error occurs.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 108).
2 From the listing on the left, select [Device Setting 2] 
[Number of paper feeding retries].
3 Specify the number of paper feeding retries.
The value can range from 1 to 12 times.
ATTENTION
The Software Operation Panel allows you to choose the color from
red, green, and blue only. To drop out a color of your choice,
configure the setting in the scanner driver.
For details, refer to the scanner driver's Help.
HINT
This setting can also be configured in the scanner driver. Note that
priority is given to the scanner driver setting.