Fujitsu Fi-7030 User Manual

Appendix
Chapter 7 Troubleshooting
Glossary
Introduction
Index
Contents
TOP
99
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Troubleshooting
A shadow appears at the top or the bottom of the
scanned image.
Have you adjusted the offset (position to start a scan or
end a scan)?
No
In [Device Setting] of the Software Operation Panel, adjust the offset in the sub-
scanning direction.
For details, refer to "Adjusting the Position to Start the Scan [Offset/Vertical
Magnification Adjustment]" (page 126).
Yes
Did you use the Page Edge Filler function to fill out the
shadow around the edge?
No
In the scanner driver or in [Device Setting 2] of the Software Operation Panel, use
the Page Edge Filler function to fill out the shadow around the edge.
For details, refer to "Removing Shadows/Streaks that Appear around the Scanned
Image [Page Edge Filler (ADF)]" (page 127).
Yes
If the problem persists, check the items in "7.4 Before You Contact the Scanner
Service Provider" (page 104) first, then contact your FUJITSU scanner dealer or
an authorized FUJITSU scanner service provider.

Fujitsu Fi-7030 Specifications

General

Optical Resolution	600 dpi
ADF Capacity	50 sheets
Interface	USB 2.0
Duplex Scanning	Yes
Scanner Type	ADF (Automatic Document Feeder)
Supported Paper Size	A4, A5, A6, B5, B6, Letter, Legal
Scanning Method	Color
Scan Speed (Color, A4, 200 dpi)	30 ppm / 60 ipm
Power Consumption	Operating: 18 W or less
Scanning Speed	30 ppm / 60 ipm
Daily Duty Cycle	Up to 4, 000 sheets