Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
40
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
Contents
Fig. 2
ATTENTION
The above condition applies when the document is set to the center
of the pick roller width.
When you use detection by overlapping, scanning thick documents
such as plastic cards will be falsely detected as multifeed.
To scan such documents, disable the multifeed window display
function of the scanner driver, the Intelligent Multifeed function, or
the multifeed detection setting.
Center
Top
Reference point
Feed
direction
Front side
(Unit: mm)
Bottom
50
HINT
Accuracy of multifeed detection may drop with some documents.
Multifeed cannot be detected for the top 30 mm of a document.
For the shaded area in "Fig. 2" (page 40), you can also specify a
length not to detect multifeeds in the Software Operation Panel.
For details, refer to "8.6 Settings Related to Multifeed Detection"
(page 132).
To Next Page
Loading...
