Fujitsu FI-800R User Manual

Cannot Connect the Scanner and a Computer via a USB Cable
Check the following points
● Is the USB cable connected properly? (page 116)
● Did you select [Auto] for the USB setting for the scanner? (page 116)
If the problem persists, refer to The First Measures to Take When You Encounter any Errors or Troubles
(page 140) and take measures accordingly. If the problem still persists, check each item in Before You
Contact the Scanner Service Provider (page 141) first, then contact the distributor/dealer where you
purchased this product. Refer to the contact information in the Contact List if supplied with this product, or
refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions
supplied with this product, and then make an inquiry.
● Is the USB cable connected properly?
Solution
Connect the USB cable properly.
For details, refer to Getting Started.
● Did you select [Auto] for the USB setting for the scanner?
Solution
If you select [Auto] for the USB setting for the scanner, the connection between the scanner and a
computer may not be able to be established.
Change the USB setting for the scanner to [USB 2.0] in the Software Operation Panel.
Troubleshooting
116

Fujitsu FI-800R Specifications

General

Scanner Type	Document Scanner
Optical Resolution	600 dpi
ADF Capacity	20 sheets
Daily Duty Cycle	4, 500 sheets
Supported Operating Systems	Windows, macOS
Color Depth	24-bit
Document Feeder Capacity	20 sheets
Document Size	A4, A5, A6, B5, B6, Legal, Letter
Scan Speed (A4, 200 dpi)	40 ppm / 80 ipm
Maximum Document Size	216 mm x 356 mm
Scanning Speed	Simplex: 40 ppm (color, 200/300 dpi) Duplex: 80 ipm (color, 200/300 dpi)