Fujitsu FI-800R User Manual

● Are the glass and rollers inside the ADF clean?
Solution
Clean the dirty parts.
For details, refer to Cleaning the Inside of the Scanner (ADF) with a Cloth (page 89).
● Are the pad unit and pick roller worn out?
Solution
Start up the Software Operation Panel to check the counters for the pad unit and pick roller, and if
necessary, replace the pad unit and pick roller.
For details, refer to Checking the Sheet Counters (page 162).
For details about replacing the pad unit and pick roller, refer to Replacing the Pad Unit (page 96) and
Replacing the Pick Roller (page 99).
● Is there any foreign matter in the ADF?
Solution
Clean the ADF.
Remove any foreign matter from the ADF.
For details, refer to Cleaning the Inside of the Scanner (ADF) with a Cloth (page 89).
● Did you place a thick document inside the Carrier Sheet/Photo Carrier Sheet?
Solution
Some papers may be too thick to place inside the Carrier Sheet/Photo Carrier Sheet.
Use documents that meet the requirements.
When scanning a thick document such as a booklet, place the document inside the Booklet Carrier Sheet
to scan it.
For details about conditions for using the Carrier Sheet/Photo Carrier Sheet/Booklet Carrier Sheet, refer to
the following:
● Conditions for Using the Carrier Sheet (page 60)
● Conditions for Using the Photo Carrier Sheet (page 62)
● Conditions for Using the Booklet Carrier Sheet (page 64)
Troubleshooting
138

Fujitsu FI-800R Specifications

General

Scanner Type	Document Scanner
Optical Resolution	600 dpi
ADF Capacity	20 sheets
Daily Duty Cycle	4, 500 sheets
Supported Operating Systems	Windows, macOS
Color Depth	24-bit
Document Feeder Capacity	20 sheets
Document Size	A4, A5, A6, B5, B6, Legal, Letter
Scan Speed (A4, 200 dpi)	40 ppm / 80 ipm
Maximum Document Size	216 mm x 356 mm
Scanning Speed	Simplex: 40 ppm (color, 200/300 dpi) Duplex: 80 ipm (color, 200/300 dpi)