Setting Item Description
Multifeed For documents that are loaded in the ADF paper chute (feeder),
configure the settings to detect overlapped documents during a
scan.
Page Edge Filler (U-turn) For documents that are loaded in the ADF paper chute (feeder),
configure the settings to fill in the shadow or streaks around the
edges of the scanned image.
Page Edge Filler (Return) For a document that is inserted into the return path opening,
configure the settings to fill in the shadow or streaks around the
edges of the scanned image.
Dropout color You can exclude a color from being scanned by selecting either
red, green, or blue (three primary colors).
Document check area specification for
Multifeed Detection
For documents that are loaded in the ADF paper chute (feeder),
specify an area to detect overlapped documents.
Intelligent Multifeed Function For documents that are loaded in the ADF paper chute (feeder),
configure the setting to automatically ignore certain patterns of
overlapped documents when the setting to detect overlapped
documents is enabled.
Number of paper feeding retries Specify the number of feeding retries when a document is not
fed from the ADF paper chute (feeder).
Cleaning Cycle Specify the cleaning cycle for the scanner inside.
Life Counter Alarm Setting Specify the replacement cycle for the consumables.
Vertical Streak Detection You can configure the settings for detecting dirt on the glass.
Vertical Streak Sensitivity Specify the sensitivity level to detect vertical streaks (dirt on the
glass) when [Enable] is selected for [Vertical Streak Detection].
AutoCrop Boundary When the scanner is set to detect the paper size automatically,
specify whether or not to optimize (round up/down) the
fractional part of the scanned image.
Power SW Control Specify whether or not to turn on/off the scanner by pressing
the [Power] button on the scanner.
High Altitude Mode Enable this mode to use the scanner at an altitude of 2,000 m
or higher.
USB Change the USB setting if a connection between the scanner
and a computer cannot be established.
Scanner Settings (Software Operation Panel)
161
To Next Page
Loading...
