Fujitsu FI-800R User Manual

The specified area is filled in white or black, according to the background color.
(1): Top = 0 to 15 mm
(2): Bottom = -7 to 7 mm
(3): Right = 0 to 15 mm
(4): Left = 0 to 15 mm
(in 1 mm increments)
ATTENTION
Note that if the target range of page edge filler is too wide, some characters near the edge may appear
missing.
HINT
● You can change the background color to black or white in the scanner driver.
For details, refer to the help for the scanner driver.
● Depending on the value you specify for the bottom margin of the page edge filler, the page edge filler
function operates as follows:
- 1 to 7 mm
Fills in the specified area with the background color from the bottom edge of the image towards the
inside.
- -1 to -7 mm
Outputs the image without filling in the specified area with the background color from the bottom
edge of the image towards the outside. (Outputs the image with the specified area added when [Page
End Detection] is set in the scanner driver.)
● This setting can also be configured in the scanner driver.
In such a case, the page edge filler of the scanner driver is used on the image which the scanner already
filled in the edges.
Scanner Settings (Software Operation Panel)
172

Fujitsu FI-800R Specifications

General

Scanner Type	Document Scanner
Optical Resolution	600 dpi
ADF Capacity	20 sheets
Daily Duty Cycle	4, 500 sheets
Supported Operating Systems	Windows, macOS
Color Depth	24-bit
Document Feeder Capacity	20 sheets
Document Size	A4, A5, A6, B5, B6, Legal, Letter
Scan Speed (A4, 200 dpi)	40 ppm / 80 ipm
Maximum Document Size	216 mm x 356 mm
Scanning Speed	Simplex: 40 ppm (color, 200/300 dpi) Duplex: 80 ipm (color, 200/300 dpi)