The specified area is filled in white or black, according to the background color.
(1): Top = -7 to 7 mm
(2): Bottom = 0 to 15 mm
(3): Right = 0 to 15 mm
(4): Left = 0 to 15 mm
(in 1 mm increments)
ATTENTION
Note that if the target range of page edge filler is too wide, some characters near the edge may appear
missing.
HINT
● You can change the background color to black or white in the scanner driver.
For details, refer to the help for the scanner driver.
● Depending on the value you specify for the top margin of the page edge filler, the page edge filler
function operates as follows:
- 1 to 7 mm
Fills in the specified area with the background color from the top edge of the image towards the
inside.
- -1 to -7 mm
Outputs the image with the specified area that is added from the top edge of the image towards the
outside.
● This setting can also be configured in the scanner driver.
In such a case, the page edge filler of the scanner driver is used on the image which the scanner already
filled in the edges.
Scanner Settings (Software Operation Panel)
174
To Next Page
Loading...
