When the ADF is open, it might close accidentally. Be careful not to get
your fingers caught.
c Press the [Scan/Stop] button for 3 seconds or more in order for the scanner to enter cleaning
mode.
d Press the [Scan/Stop] button.
The feed/eject rollers rotate a certain amount simultaneously.
As a guideline, pressing the [Scan/Stop] button seven times will rotate the feed rollers/eject
rollers one revolution.
Be careful not to touch the rollers with your hand while they are
rotating.
e Put a piece of cloth moistened with Cleaner F1 or a sheet of Cleaning Wipe against the surface
of the rotating feed/eject roller, and wipe horizontally to clean dirt and dust off the whole
surface.
Make sure that it is wiped properly because black residue on the roller will affect the feeding
performance.
5 Close the ADF.
For details, refer to How to Close the ADF (page 33).
Be careful not to get your fingers caught when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, documents may not be fed into the ADF.
6 Clear the sheet counter after cleaning.
Start up the Software Operation Panel and clear the counter.
For details, refer to Clearing the Sheet Counters (page 164).
Daily Care
92
To Next Page
Loading...
