Begin as follows:
a
> s s>s
Message UUS Inhib.
receiv.
s Press the »External«or»Internal«
softkeytoenableorinhibitreceptionof UUS1
messages. FOR EXAMPLE.:
»external«: .Reception of external mes
-
sages inhibited.
»internal«: Reception of internal mes
-
sages is possible.
Inhib. receiv. / UUS
external
internal
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Error when sending or receiving an SMS
Error while sending an SMS
Acorresponding errorcodeis displayed inthe eventthat forsomeunseenreason it isnot possibleto trans
-
mitanSMS. ContacttheSMSServicecenterofyournetworkserviceprovider /carriertofindoutwhicher
-
ror codes are displayed.
Error while receiving an SMS
TheremaybevariousreasonsforitnotbeingpossibletoreceiveanSMS,orforonlyhavingvoiceoutput:
•
The feature SMS has not been applied for(and approved) atyour network service provider and/or
theprovideroftheSMS ServiceCenter.
•
The SMS has beentransferred byoutside serviceproviders which did not transmitthis message as
anSMS.
•
Permanentnumbersuppression(inhibit)isactivatedfor yourISDNconnection.
•
Ten SMS messages have already been stored in your telephone, preventing any further SMS mes-
sagesfrombeingreceived.
Silent signalling
If you do notwish calls to besignaled with theprogrammed ringermelody andvolume, you can active the
»Silent signalling« feature. Depending on the specific setting, all calls will be displayed optically or along
withabriefacoustic signal. To set the volumefor thebriefacoustic signal,proceed as described on page45
or »R« in the display shows that the function »Station guarding« is activated.
»No« The function »Station guarding« is deactivated.
»ok« Calls are signaled optically only (»Q« shown in the display).
»Ringing signal off« Calls are signaled first by a brief acoustic signal and then only optically
(»q«).
Only for msn-1 The functions described aboveare configured onlyfor MSN-1. This as
-
sumesthatseveralMSNshavebeenconfiguredinthesystemtelephone.
a
ss
Quiet No / Ringing signal 0ff/ ok
Telephone operation
45
To Next Page
Loading...
Need help?
General
