»Fixed« Directcallforwarding:
Allcallsforanumberforwhich„fixed“callreroutinghasbeenconfiguredarererouted.
Yourtelephonewillnotring,whenthisnumberiscalled.
Youcanconfiguresimultaneousdelayedcallreroutingandcallreroutingonbusy. Ifyouhaveconfigureda
set call rerouting, cancel this function before configuring a new (other) call rerouting function.
If you operate your telephone with a pabx, please observe the call rerouting information (call
forwarding) given in the operating instructions for your pabx.
Ifyourisdirectlyconnectedtothenetworkterminationunit,pleaseobservethecorresponding
information supplied by the service provider.
Activate call forwarding
The following example describes how to set up MSN 1 for permanent call forwarding.
Begin as follows:
a
Mssss
Setting Call
rerout.
Fixed MSN-1
t Enter the number to which the calls are to be
forwarded.
In this example: »0123456789«.
Call forwarding direct
MSN-1>0123456789_
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
O Confirm your entry with OK.
Call rerouting has been registered. The three
dotsattherightlowercornerflashalternately.
Call forwarding direct
msn-1}0123456789 ...
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Viewing current call forwarding
Whenthe telephone is idle, a »U«on the second line indicates that Call rerouting has beenactivated. Press
the»Info«softkeyifyouwishtohavemoreinformationdisplayedfortheprogrammedcallrerouting.
Deactivating call rerouting
The following example describes how to set up MSN 1 for permanent call forwarding.
a
Ms s sss
Setting Call rerout. Off Fixed MSN-1
Special features for the Swiss version
InthedefaultsettingthetelephoneisdesignedforbeingoperatedattheinternalISDN portof apabx.Ifyou
wishtouseyourtelephoneatthenetworkterminationunitor atathird-party pabx,youwillhavetochange
the call rerouting protocol (»Keypad« or »ETSI«) as described below.
Use at a point-to-multipoint connection (network termination unit)
a
Mss
t
O>ss
Configu
-
ration
Service
Telephone PIN
Swiss_
Var
keypad
Settings
67
To Next Page
Loading...
