Begin as follows:
a
M s ss
Configuration Inhibiting
filter
PIN
t
O
Enter the new PIN.
In this example: »1234«.
Confirm your entry with OK.
Change PIN
>1234_
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Attention:ThePINisalsoresetto(0000)afterexecutingtheserviceresetforrestoringtheiniti
-
al state (see page 92).
Menu
Accessing a menu via the PIN:
Intheseoperatinginstructions,access to menus is always described without the use of a PIN. If you set the
PIN protection for a specific menu, you can access this menu as described in the following example.
Begin as follows:
a
Msss
Configuration inhibit Menu
Protecting access to the telephone menus by a PIN
With the telephone PIN you can restrict access to the telephone menus (»Configuration«, »Set-
ting«and»Program nos. «)andprotectthestoredchargedatafromunauthorizeddeletion.Before
amenucanbecalledup(e.g.menubuttonand»Configuration«key),thePINmustbeenteredwhen
the protection feature is active.
You can set access restrictionsseparately forthe»Configuration«,»Setting« and »Program
nos. « menus. The »inhibit« and »Service« menus are always protected by the telephone PIN.
Access restrictions for the »Configuration« menu will also apply for deleting stored charge data.
s Press the »Configuration« softkey to
activate or deactivate the PIN protection
feature.
ªªªªªªªªªªªªªªªªªªªªª
Configuration
Setting
Program nos.
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
A check mark next to »Configuration
«indicatesthattheaccessrestrictionisactive.
Press the »Configuration« softkey
again to deactive the protection feature.
s
Outgoing
This feature requires an »Extended Configuration« to show on the display.
Configuration
75
To Next Page
Loading...
Need help?
General
