EasyManua.ls Logo

Funkwerk elmeg CS400xt - Configuring and Setting Up the System Telephone

Funkwerk elmeg CS400xt
129 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Monitoring costs
50
Displaying information during a call
Thedisplaysduringcallsdescribedbelowdependonyourindividualsettingsandcantherefore
be different for each connection. Correct charge display is shown only if you have applied at
your network service provider for transmission of charges during calls.
g
s
During a call, the upper rows of the display
show the number or the name of the other
party (»TONY«) and the duration of the en
-
tire call (»02. 43«).
Press the »display« softkey.
BEATRICE }
02.43 MSN-1
Memo
show
Keypad
Mute
park
You are then shown other information avail
-
able on the current connection.
Date (»29.05.07«), Time (»07:41«),
associated number (»0987654321«),
Costs(»0. 36 EUR«),durationofthecall
(»02. 55«)
TONY
to MSN-1
29.05.07 07:41
0987654321
0,36 EUR 02.55
<> Pressthearrowkeytodisplayfurtherinformation(ifavailable).
If you are the destination of call rerouting, you will be shown the number that is being re-
routed(»U{123«),whenitistransferred.
You see the normal display again during a
connection.
BEATRICE 03.33 }
03:33
memo
Display
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
a Afterfinishingthecallyou seeforabout5 sec
-
onds the following display.
ªªªªªªªªªªªªªªªªªªªªªª
TONY
Costs 0.36 EUR
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Programming calling line identification mode (CLIP/CLIR/COLP/COLR)
Begin as follows:
a
Ms sss
Configuration Display MSN ext.
»Incoming« Pressthe»Incoming«softkeytohavethenumbersdisplayedornotdisplayedatthe
calledparty. Acheckmarkdisplayednexttothesoftkeyindicatesthatcallinglineiden
-
tificationisactive.
»Outgoing« Pressthe»Outgoing«softkeytohavethenumbersdisplayedornotdisplayedatthe
calledparty. Acheckmarkdisplayednexttothesoftkeyindicatesthatcallinglineiden
-
tificationisactive.

Table of Contents