<>
O
Use the arrow buttons to set the desired mel
-
ody. The bar in the display indicates the cur
-
rent status.
Confirm your entry by pressing ok.
ˆ Select melody {}
MSN-1,internal 3
−©−−−−−−−−−−
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Setting the volume
In the »Program MSN-1« menu press the »Volume« softkey and then the »internal«or»ex
-
ternal« softkey.
<>
O
Use the arrow buttons to set the volume and
theringermelody.Thebarinthedisplay indi
-
cates the current status.
Confirm your entry by pressing ok.
Select call signal {}
MSN-1
- ©©©−− +
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Inadditiontosteadyvolumes,youcanalsoconfigurecallsignalingwithanincreasingvolume.Whenthisis
done, the volume of the ringingtone is increased automatically as the call is signaled. Whentheincreasing
volume function is configured the following symbol is shown in the display »
©©©©©©«
Entering a name for an extension number
You can assign your own names (max. 8 characters) to the MSN extension numbers.
On each of the buttons on the push-button set there are three or four letters of the alphabet. You can
advance through the letters by pressing the appropriate button repeatedly (see page12). If there are two
consecutive letters on the same button of the push-button set, press the right arrow button after entering
the first letter and then enter the next letter.
s
t
O
Inthe »Program MSN-1«menupress the
»MSN Name« softkey«.
Enterthenamedesiredname.Inthisexample:
»private«. Confirm your entry with OK.
Own MSN esignation
MSN-1>private
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Programming a default call forwarding number
If you do not wishto accept a call, you canforward this call directly to a different phone number (see page
20).
Ifyoufrequentlyforwardcallstothesamenumber,youcanusethisnumberasadefaultsettinginyourpho
-
Configuration
81
To Next Page
Loading...
Need help?
General
