Field Description
Event List
Select the event list you want which has been created in Local
Services->Scheduling->Trigger.
Event List Condition
For the selected chains of events, select how many of the con-
figured events must occur for the operation to be initiated.
Possible values:
• 0// (default value): The operation is initiated if all events oc-
cur.
• ?The operation is initiated if a single event occurs.
• *: The operation is initiated if none of the events occurs.
• ? : The operation is initiated if one of the events does
not occur.
Reboot device after
Only if Command Type = ;#
Enter the timespan in seconds that must elapse after occur-
rence of the event until the device is restarted.
The default value is seconds.
MIB/SNMP Variable to
add/edit
Only if Command Type = (>7-*(
Select the MIB table in which the MIB variable whose value
shall be changed is saved. First, select the System, then the
MIB Table. Only the MIB tables present in the respective area
are displayed.
Command Mode
Only if Command Type = (>7-*(
Select how the MIB entry is to be manipulated.
Possible settings:
• 4$ =&$ ) (default value): An existing entry
shall be modified.
• 4 (> ): A new entry shall be created.
Index Variables
Only if Command Type = (>7-*(
Where required, select MIB variables to uniquely identify a spe-
cific data set in MIB Table, e.g. 4=. The unique
Funkwerk Enterprise Communications GmbH
21 Local Services
bintec Rxxx2/RTxxx2 449
To Next Page
Loading...