Ordering Options for the DMC-40x0
Overview
The DMC-40x0 can be ordered in many different configurations and with different options. This section provides
information regarding the different options available on the DMC-40x0 motion controller, interconnect modules and
internal amplifiers. For information on how to order a controller with these options, see our DMC-40x0 part number
generator on our website.
http://www.galilmc.com/products/dmc-40x0-part-number.php
DMC-40x0 Controller Board Options
DIN – DIN Rail Mounting
The DIN option on the DMC-40x0 motion controller provides DIN rail mounts on the base of the controller. This
will allow the controller to be mounted to any standard DIN rail.
Part number ordering example: DMC-4010(DIN)-C012-I000
12V – Power Controller with 12VDC
The 12V option allows the controller to be powered with a regulated 12V supply. In most cases, this option is only
appropriate if no Galil amplifiers are used.
Part number ordering example: DMC-4010(12V)-C012-I000
TRES – Encoder Termination Resistors
The TRES option provides termination resistors on all of the main and auxiliary encoder inputs on the DMC-40x0
motion controller. The termination resistors are 120 Ohm, and are placed between the positive and negative
differential inputs on the Main A, B, Index channels as well as the Auxiliary A and B channels as shown below.
Note: Single ended encoders will not operate correctly with the termination resistors installed. If a combination of
differential encoder inputs with termination resistors and single ended encoders is required on the same interconnect
module is required, contact Galil directly.
Part number ordering example: DMC-4010(TRES)-C012-I000
Appendices • 201 DMC-40x0 User Manual
To Next Page
Loading...
