AMP Internal Amplifier Options
ISAMP – Isolation of power between each AMP amplifier
The ISAMP option separates the power pass-through between the Axes 1-4 amplifier and the Axes 5-8 amplifier.
This allows the 2 internal amplifiers to be powered at separate voltages.
If the ISCNTL option is NOT ordered on the DMC-40x0, the amplifier with the higher bus voltage will
automatically power the controller. The amplifier with the higher voltage, and the voltage level does not have to be
specified during time of purchase as long as the voltage falls within the range of 20-80VDC.
This option is only valid on the 5-8 Axes amplifier board.
Part number ordering example: DMC-4080-C012-I000-I000-D3040-D3040(ISAMP)
100mA – 100mA Maximum Current output for AMP-43140
The 100mA option configures the AMP-43140 (-D3140) for 10mA/V gain with a maximum current output of
100mA.
This option is only valid with the AMP-43140.
Part number ordering example: DMC-4040-C012-I000-D3140(100mA)
SSR – Solid State Relay Option for AMP-43140
The SSR option configures the AMP-43140 (-D3140) with Solid State Relays on the motor power leads that are
engaged and disengaged when the amplifier is enabled and disabled. See the -SSR Option in the AMP-43140
section of the Appendix for more information.
This option is only valid with the AMP-43140.
Part number ordering example: DMC-4040-C012-I000-D3140(SSR)
DMC-40x0 User Manual Appendices • 204
To Next Page
Loading...
