Figure 6.6: Velocity vs. Time Motion 4
Figure 6.7: Velocity cts/sec vs. Time (msec) with IT
Note the controller treats the point where the velocity passes through zero as the end of one move, and the beginning
of another move. IT is allowed, however it will introduce some time delay.
Trip Points
Most trip points are valid for use while in the position tracking mode. There are a few exceptions to this; the AM
and MC commands may not be used while in this mode. It is recommended that MF, MR, or AP be used, as they
involve motion in a specified direction, or the passing of a specific absolute position.
Chapter 6 Programming Motion • 85 DMC-40x0 User Manual
To Next Page
Loading...
