Chapter 3. Initial Setup and Programming
28 AT600 User’s Manual
3.3.3 Changing the Measurement Type or Value for Totalizer Screens (cont.)
To change the totalizer measurement type, proceed as follows:
If the first value is selected to
Time, the unit will display the time unit. If the first value is selected to Forward Totals,
Reverse Totals, Net Totals
, the unit will be the selected unit in the “Units Setting” The available time measurement
units are seconds, minutes, hours or days. To choose the appropriate unit, from the highlighted measurement type, press
the [] or [] buttons until the measurement unit is highlighted.
From the display screen, press either the [] or [] buttons until the
measurement type is highlighted.
Once the type is highlighted, press
[] to open the Display/Decimal option.
The screen changes to
Totalizer Type. Press the [] and [] buttons to scroll to
the appropriate parameter. Available parameters include: F
orward Totals,
Reverse Totals, Net Totals and Time
. Once you have chosen the type, press [] to
select the value, and then [
] again to confirm the selection or [] to cancel the
selection.
Once the unit is highlighted, press
[] to open the Display/Unit option.
Press the [] and [] buttons to scroll to the appropriate unit, and press
[] to
select the unit, and then [
] again to confirm the selection or [] to cancel the
selection.
Note: If you selected “Time”, the available units are seconds, minutes, hours
and days.
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
Total m^3
Forward 0.000e+00
Reverse 0.000e+00
Forward Totals
Totalizer Type
Reverse Totals
Net Totals
Time
TOTAL Seconds
Time 0.0000
Reverse 0.000e+00
Display/Unit
Seconds
Minutes
Hours
Days
To Next Page
Loading...
