GE AT600 - Setting Analog Measurements; Setting Base Value and Full Value

AT600 User’s Manual 41
Chapter 3. Initial Setup and Programming
3.6.1a Setting Analog Measurements
3.6.1b Setting Base Value and Full Value
Select the desired Output number with the [] or [] arrow keys, and press
[] to enter the relevant configuration menu.
Select Measurement and press
[]. The following screen appears.
In the Measurement menu, select the type of analog output to be used, and press
[√]. The screen returns to the previous display.
Base Value is the flow rate represented by 4 mA, and Full Value is the flow rate
represented by 20 mA. In the Analog Output menu, select
Base Value or Full
Value
and press []. A screen similar to the following appears.
Press
[] again and a screen similar to the following appears.
Note: The units that appear will be the units selected in Units Setting on page
28.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the
Base Value or Full Value and press [].
Repeat these steps to set the Full Value setting. Press [
] to return to the Analog
Output A
menu.
Input/Output
Analog Output A
Digital Output B
Digital Output C
Modbus/Service Port
Analog Output A
Measurement
Base Value
Full Value
Calibrate
Measurement
Velocity
Act Volumetric
Std Volumetric
Mass
Analog Output A
Measurement
Base Value
Full Value
Calibrate
Base Value
Base Value
0.0000 m/s
Base Value
UNIT: m/s
0.0000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[