GE AT600 - Density; Password

AT600 User’s Manual 37
Chapter 3. Initial Setup and Programming
3.5.3 Density
3.5.4 Password
To configure flow density, under User Preference, use the [] or [] arrow
key to select Density and press
[]. The following screen appears.
Use the [] or [] arrow keys to highlight the desired density type and press
[√].
Press [√] again and a screen similar to the following appears.
Use the arrow keys to select the correct density value and press [√]. The screen
returns to the previous display.
To set up a password, under
User Preference, use the [] or [] arrow key to
select
Password and press [√]. The following screen appears.
Use the [] or [] arrow key to change the digit value and press [√]. Press the
[
] key to return to the Password screen.
User preference
Settings
Units Setting
Density
Password
Density
Density (Act)
Density (Std)
Density
Density (Act)
1000.000 Kg/m^3
Density (Act)
UNIT: Kg/m^3
1000.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
User preference
Units Setting
Density
Password
Setting
Enter the password
9999
]MOVE
]UNDO [ ]SAVE
]
]
]
]MODF