GE AT600 - Programming the Transducer; Setting the Standard Transducer

Chapter 3. Initial Setup and Programming
62 AT600 User’s Manual
3.7.3 Programming the Transducer
3.7.3a Setting the Standard Transducer
Select Transducer and press [√]. The following screen appears.
Select
STD and press [√]. A screen similar to the following appears.
Press
[] again, and a screen similar to the following appears.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the Transducer setting, and press
[] to return to the
previous screen. Then press [
] to return to the Transducer screen.
Note: Available transducer types for the AT600 are listed in Table 4 below.
Sensor Setup
Meter Setup
Pipe
Transducer
Traverses
Transducer
SPEC
STD
SPEC
STD
SPEC
STD
0
STD
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[