GE AT600 - Changing the Measurement Type or Value for Totalizer Screens

AT600 User’s Manual 27
Chapter 3. Initial Setup and Programming
3.3.3 Changing the Measurement Type or Value for Totalizer Screens
The totalizer screen appears similar to Figure 31 below.
Figure 31: The Totalizer Screen
To change the number of decimal places in the value displayed on a totalizer screen, proceed as follows:
From the display screen, press either the [] or [] buttons until the value is
highlighted.
Once the value is highlighted, press
[] to open the Display/Decimal option.
Use the [] and [] buttons to scroll to the appropriate value. (Available
options include 0, 1, 2, 3, 4, and Sci (Scientific Notation). Press [
] to select the
value, and then [
] again to confirm the selection or [] to cancel the selection.
Total m^3
Forward 0.000e+00
Reverse 0.000e+00
Totalizer
Reset Totalizer
Error Code
Values
Measurement Type
Start/Stop Totalizer
Totalizer Units
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
Total m^3
Forward 0.000e+00
Reverse 0.000e+00
Display/Decimal
2
3
4
Sci