GE AT600 - Setting the Lining

Chapter 3. Initial Setup and Programming
60 AT600 User’s Manual
3.7.2b Setting Pipe Material (cont.)
3.7.2c Setting the Lining
Press [] again, and a screen similar to the following appears.
Note: The units that appear will be the units selected in Units Setting on page
28.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the Pipe SOS value and press
[]. Press [] to return
to the previous display.
Press [
] twice to return to the Pipe menu.
In the Pipe menu, select Lining and press [√]. The following screen appears.
If there is no lining, select No and press [√] to return to the previous screen.
If there is a lining, select
Yes and press [√] twice. A screen similar to the
following appears.
To set the lining thickness, select it and press
[]. A screen similar to the
following appears.
Pipe SOS
Pipe SOS
2400.000 m/s
Pipe SOS
UNIT: m/s
2400.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Pipe
Pipe ID
Wall Thickness
Pipe Material
Lining
Lining
No
Yes
Lining
Lining Thickness
Lining Material