GE AT600 - Programming the Fluid Type

AT600 User’s Manual 69
Chapter 3. Initial Setup and Programming
3.7.5 Programming the Fluid Type
If customers know the fluid type, the meter will run calculations based on customer input; however, if customers do not
know the fluid type, they should open the Tracking Windows function discussed below. Moving the transducers is not
necessary.
Select
Fluid Type and press [√]. The following screen appears.
If the fluid type is water, select
Water and press [] to return to the previous
screen.
If the fluid is not water, select Other and press
[]. A screen similar to the
following appears.
If the tracking window is not applied, select
No and press []. A screen similar to
the following appears. In it, you enter the
Fluid SOS.
If you don't know the fluid SOS, you can enable the tracking window so that the
meter detect it automatically. If the "tracking window" is applied, select Yes and
press [√]. A screen similar to the following appears. Enter the
Maximum SOS
and
Minimum SOS.
Note: Fluid SOS, Maximum SOS and Minimum SOS all operate in the same
manner.
Press
[] again, and a screen similar to the following appears.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the Fluid SOS setting, and press
[] to return to the
previous screen. Then press [
] to return to the Sensor Setup screen.
Sensor Setup
Traverses
Fluid Type
Fluid Temperature
Transducer Spacing
Fluid Type
Water
Other
Tracking Window
No
Yes
Fluid SOS
Fluid SOS
1496.000 m/s
Fluid SOS
UNIT: m/s
1496.000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[