GE AT600 - Disable the Digital Output; Setting the Pulse Output

Chapter 3. Initial Setup and Programming
44 AT600 User’s Manual
3.6.2a Disable the Digital Output
3.6.2b Setting the Pulse Output
Setting Measurement Type
Setting Pulse Value
To specify the error handling status in the Digital Output B menu, select
Off and
press
[] twice.
The Pulse output will put out a square wave pulse for each unit of flow that
passes through the pipeline. Select
Pulse and press []. The following screen
appears.
Select
Measurement and press []. A screen similar to the following appears.
In the
Measurement menu, select the type of analog output to be used, and press
[]. The screen returns to the previous display.
Use the [] or [] arrow keys to select Pulse Value and press []. A screen
similar to the following appears.
Digital Output B
Off
Pulse
Frequency
Alarm
Digital Output B
Off
Pulse
Frequency
Alarm
Pulse
Measurement
Pulse Value
Pulse Time
Test Pulse
Measurement
Forward Batch Total
Reverse Batch Total
Net Batch Total
Pulse
Measurement
Pulse Value
Pulse Time
Test Pulse