GE AT600 - Page 57

AT600 User’s Manual 45
Chapter 3. Initial Setup and Programming
Setting Pulse Value (cont.)
Setting Pulse Time
The Pulse Value, the amount of flow represented by one pulse, is displayed. (For
example, 1 pulse = 10 m^3.) To change the existing number, press
[] and a
screen similar to the following appears.
Note: The units that appear will be the units selected in Units setting on page
28.
To change the
Pulse Value, use the [] or [] arrow key to select the digit to be
changed, use the [] or [] arrow keys to provide a new number and press
[]
to save. Press [] to return to the Pulse menu.
Use the [] or [] arrow keys to select
Pulse Time and press []. A screen
similar to the following appears.
The Pulse Time, pulse width, is displayed. To change the existing number, press
[] and a screen similar to the following appears.
To change the
Pulse Time, use the [] or [] arrow key to select the digit to be
changed, use the [] or [] arrow keys to provide a new number and press
[]
to save. Press [] to return to the Pulse menu.
Pulse Value
Pulse Value
10.0000 m^3
Pulse Value
UNIT: m^3
10.0000
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Pulse
Measurement
Pulse Value
Pulse Time
Test Pulse
Pulse Time
Pulse Time
5 ms
Pulse Time
UNIT: ms
5
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[