GE AT600 - Page 58

Chapter 3. Initial Setup and Programming
46 AT600 User’s Manual
Setting Pulse Error Handling
Test Pulse
To change the
Error Handling status, select it on the screen and press []. The
following screen appears.
Select
Hold or Stop. Hold directs the meter, in case of a flow measurement error,
to keep sending the pulses sent at the last good reading. Stop directs the meter, in
case of measurement error, to stop pulsing.
Press
[], and the screen returns to the previous display. Press [] to return to the
Digital Output menu.
To test the pulse output, select
Test Pulse and press []. The following screen
appears.
Press
[]. A screen similar to the following appears.
Press
[], and the screen returns to the previous display. Press [] to return to the
Digital Output menu.
Enter a number of pulses and the instrument will send that many out. Note on
your measurement system that the right number of pulses were received.
After testing,
press [] to return to the Digital Output menu.
Pulse
Pulse Value
Pulse Time
Test Pulse
Error Handling
Error Handling
Stop
Hold
Pulse
Pulse Value
Pulse Time
Test Pulse
Error Handling
Test Pulse
Test Pulse
0
Test Pulse
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[