GE AT600 - Units Setting

Chapter 3. Initial Setup and Programming
36 AT600 User’s Manual
3.5.2 Units Setting
To check or change velocity flow units, under User Preference, use the [] or
[] arrow key to select Units Setting and press
[]. The following screen
appears.
Under Units Setting menu, use the [] or [] arrow key to select the unit that
need to be changed and press [√] to reach the next level screen.
Note: Select “Velocity” as an example.
If you don’t want to change the unit, select No and press
[]. If you do want to
display the unit, select Yes, press
[] twice, and the following screen appears.
If no change is desired, press
[] twice and the screen returns to the Units Setting
menu. To change the measurement type, select the desired option, press []
twice, and a screen similar to the following appears.
Confirm the selected units, press
[] three times and return to the Units Setting
menu.
User Preference
Settings
Units Setting
Density
Password
Units Setting
Velocity
Act Volumetric
Std Volumetric
Mass
UnitsSet / Velocity
No
Yes
UnitsSet /Velocity
English
Metric
Vel /
Ft/s