GE AT600 - Display; Backlight; Timeout

Chapter 3. Initial Setup and Programming
38 AT600 User’s Manual
3.5.5 Display
3.5.5a Backlight
3.5.5b Timeout
To turn the backlight OFF or ON, under User Preference, use the [] or []
arrow key to select
Display and press [√]. The following screen appears.
Select
Backlight, press [√], and a screen similar to the following appears.
Select OFF or ON, press [√] twice, and the screen returns to the previous
display.
To provide a timeout, under
Display, select Timeout and press [√]. A screen
similar to the following appears.
Note: The default value for the timeout is 0, so users must set a timeout if they
wish one.
Press [√] again, and a screen similar to the following appears.
User preference
Units Setting
Density
Password
Display
Display
Backlight
Timeout
Display/Backlight
OFF
ON
Display
Backlight
Timeout
Timeout
Timeout
19 S