GE AT600 - Starting or Stopping Totalizer Measurement

AT600 User’s Manual 29
Chapter 3. Initial Setup and Programming
3.3.4 Starting or Stopping Totalizer Measurement
To start or stop totalizer measurements:
From the display, press either the [] or [] buttons until the
Start/Stop icon
(either an arrow icon for Start or a two-bar icon for Stop) is highlighted.
Once the value is highlighted, press [
] to start or stop totalizing.
The icon then changes to indicate the new status (start or stop).
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00
TOTAL m^3
Forward 0.000e+00
Reverse 0.000e+00