GE AT600 - Page 73

AT600 User’s Manual 61
Chapter 3. Initial Setup and Programming
3.7.2c Setting the Lining (cont.)
Press [] again, and a screen similar to the following appears.
Note: The units that appear will be the units selected in Units Setting on page
28.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the Lining Thickness value and press
[] to return to
the previous display. Then press [
] to return to the Lining screen.
Select the appropriate option and press [
] to return to the previous screen.
If the material is not listed, select
Other and press [√] twice. A screen similar to
the following appears.
Table 3: Preprogrammed Lining Materials
Name Lining Material
Tar Epoxy Tar Epoxy
Pyrex Glass Pyrex Glass
Asbestos Cement Asbestos Cement
Mortar Mortar
Rubber Rubber
Teflon Teflon (PFTE)
Press
[] again, and a screen similar to the following appears.
Note: The units that appear will be the units selected in Units Setting on page
28.
Use the [] or [] arrow key to select the digit to be changed, use the [] or
[] arrow keys to change the Lining SOS value and press
[]. Press [] to
return to the previous display.
Lining Thickness
Lining Thickness
0.000 mm
Lining Thickness
UNIT: mm
0.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Lining Material
MORTR
RUBBR
REFLN
Other
Lining SOS
Lining SOS
2000.000 m/s
Lining SOS
UNIT: m/s
2000.00
0
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[