GE AT600 - Page 65

AT600 User’s Manual 53
Chapter 3. Initial Setup and Programming
Selecting the Baud Rate (cont.)
Selecting the Modbus Address
Selecting the Bits/Parity
The default baud rate is 115200. Select the appropriate baud rate and press
[],.
The screen returns to the previous display.
To set the address, in the Modbus menu, select Address and press []. A screen
similar to the following appears.
Press
[] again, and a screen similar to the following appears.
Use the [] or [] arrow keys to change the address number (from 1 to 254 —
not 0) and press
[]. Press [] to return to the previous screen.
To set the
Bits/Parity, in the Modbus menu, select it and press []. A screen
similar to the following appears.
Baud Rate
19200
38400
57600
115200
MODBUS
Baud Rate
Address
Bits/Parity
Stop Bits
Address
Address
1
Address
1
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
MODBUS
Baud Rate
Address
Bits/Parity
Stop Bits