Chapter A3: Worklist
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A3-19
Operator Manual © 2008 General Electric Company. All rights reserved.
Edit Patient Information
Patient information can only be edited before any procedure has been opened.
NOTE: You may only edit patient information for one procedure at a time. If multiple procedures are
selected, the [PATIENT INFORMATION] button is disabled.
1. Select the procedure from the Worklist.
2. Press [PATIENT INFORMATION].
The Patient Information screen appears.
3. Edit the information as necessary.
4. Press [SAVE] to record the changes and return to the Worklist.
Pressing [CANCEL] closes the Patient Information screen without saving changes.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
