Chapter A5: Image Viewer
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A5-1
Operator Manual © 2008 General Electric Company. All rights reserved.
Chapter A5: Image Viewer
The Image Viewer screen (Figure A5-1) appears on the touch panel once an exposure is taken in a live
exam or when an image series is chosen from the Image Management screen for review. This screen is
where images are adjusted and viewed.
Topics covered include:
• Overview
(p. A5-1)
• Tool Panel Selection
(p. A5-4)
• Select Images to View
(p. A5-5)
• Change Image Display
(p. A5-6)
• Adjust Images
(p. A5-7)
• Annotate and Mask Images
(p. A5-9)
– Customize System Annotations
(p. A5-12)
– Add Image Annotations
(p. A5-13)
– Delete Image Annotations
(p. A5-15)
– Adjust Image Shutter (Crop Image)
(p. A5-15)
• Re-process Images
(p. A5-17)
• Determine if Images should be Retaken (DEI)
(p. A5-18)
• Change Pointer Controls
(p. A5-21)
• Apply Quality Check Indicator (Auto Tag)
(p. A5-22)
• Print Images
(p. A5-22)
• Send Images
(p. A5-27)
• Save Changes to Images
(p. A5-27)
Overview
The Viewer shows all images in the study. All series within the study are listed and can be seen in the
Viewer.
The left side of the screen contains all the image selection and adjustment tools. Most of the tools are
categorized into panels that can be selected to reveal different functions.
The majority of the screen (Figure A5-1) is devoted to image display. The images on the right side of the
screen update as adjustments are made. You are able to view single or multiple images at once. When
viewing multiple images, an aqua border identifies the currently selected image.
Table A5-1 describes the functions for the Image Viewer screen.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
