GE Definium AMX 700 - Chapter A3: Worklist; Overview

Chapter A3: Worklist
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A3-1
Operator Manual © 2008 General Electric Company. All rights reserved.
Chapter A3: Worklist
The Worklist is the starting point for patient set up and selecting procedures for acquisition. All exams
begin from this screen.
The Worklist information and functions are based on DICOM standards.
This chapter explains the procedures for entering data into the system and setting up a patient.
Topics covered include:
• Overview
(p. A3-1)
– Patient List Columns
(p. A3-6)
• Manage List / Find Procedures
(p. A3-7)
– Search
(p. A3-7)
– Sort by Column
(p. A3-7)
– Filter List
(p. A3-8)
– Refresh
(p. A3-11)
• Select Procedures
(p. A3-12)
• Delete Procedures
(p. A3-12)
• Add / Edit Patient Information
(p. A3-15)
– Overview
(p. A3-15)
– Add Patient
(p. A3-18)
– Edit Patient Information
(p. A3-19)
Overview
The Worklist (Figure A3-1) shows scheduled, completed, discontinued, suspended, and active procedures.
The majority of the Worklist is the Patient List. The Patient List is a large table made of columns and rows.
Each row in the list is a procedure, or exam, to be performed. A patient may have multiple procedures
(rows) on the Worklist.
Procedures listed can be classified under two categories:
• Locally entered procedures: This category refers to procedures entered directly on the mobile unit or
system workstation by manually entering the information. Locally entered procedures are only
available to the unit or workstation that they were entered on. They do not update automatically and
no other units or workstations can access them.
• Hospital Information System (HIS) or Radiology Information System (RIS) Procedures: This category
refers to procedures that the Worklist can automatically update from the central HIS/RIS database.
Other units or workstations can be configured to access these procedures. If the GE Portable DR
Detector is used in a mobile unit, the Worklist can only update with new information from the HIS or
RIS if the unit is connected to the facility network.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).