Chapter A5: Image Viewer
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A5-12
Operator Manual © 2008 General Electric Company. All rights reserved.
Customize System Annotations
Follow this process to customize the system annotations that appear on the image.
1. Select the Annotations/Mask panel, if necessary.
2. Press [CUSTOM].
The Annotation screen (Figure A5-7) appears.
Figure A5-7 Custom Annotation selections
3. Select (check) the annotations you want to appear.
4. Adjust the Font Size, if necessary.
The available font sizes are:
–-2 (smallest)
–-1
–N (normal)
–+1
–+2
–+3 (largest)
5. Press [OK].
[CANCEL] closes the screen and leaves the selections unchanged.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
