Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-40
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure A7-29 Preferences - Protocols screen
Backup Protocol Database to CD
The Backup function allows you to save the entire protocols database (parameters) to a CD. This is
important when editing protocols; backup ensures that the current database stays intact. Backup is also
important in case of system failure and all protocol information is lost. If necessary, the old database can
be retrieved and used.
Follow this process to back up the database to a CD.
NOTE: Always use a new, blank CD-R for each back up.
DO NOT use re-writable (CD-RW) disks. The system cannot write to this type of disk.
1. If necessary, connect the external CD drive to the unit.
2. Insert a blank CD into the CD tray.
3. From the Worklist screen, press [UTILITIES].
The Utilities screen appears.
4. Select Preferences > Protocols.
5. Press [BACK UP].
A message appears: “Press OK to continue with Protocol Database back up.”
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
