Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-43
Operator Manual © 2008 General Electric Company. All rights reserved.
1. Press [ADD CAT] or [EDIT CAT].
If editing a category, select the category first, then click [EDIT CAT].
The Add Category (or Edit Category) screen appears.
2. Type a Category Name. (Use underscores instead of spaces.)
3. From the Position Category After drop-down list, select the placement of the new category on the
category list.
4. Press [OK].
5. Continue with Add or Edit Exam
(p. A7-43).
NOTE: Exams and views must be added or copied into the new category in order for it to be fully functional.
Add or Edit Exam
NOTE: The screens and process to edit an exam are the same as for adding a exam.
From the Exam Menu:
1. Select the category for the new exam.
2. Press [ADD EXAM] or [EDIT EXAM].
The Add Exam (or Edit Exam) screen appears
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
