Appendix B: Login Administration
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) B-4
Operator Manual © 2008 General Electric Company. All rights reserved.
Working with Groups
The Group and Permissions Mapping tab (Figure B-2) allows you to add groups, remove groups, and
assign privileges to groups. On this screen, the four privileges categories are at the top of the screen
(columns) and the group names are at the left edge of the screen (rows).
Figure B-2 Group and Permissions Mapping tab
Add Groups
1. Select the Group and Permissions Mapping tab, if necessary.
2. Click [ADD GROUP].
3. Type a name for the group in the text box that appears near the bottom of the screen (Figure B-3).
Figure B-3 Add group text box
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
