Chapter A8: Quality Assurance Process and Maintenance
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A8-3
Operator Manual © 2008 General Electric Company. All rights reserved.
Perform Detector Check
Follow this process to perform a Detector Check.
1. Press the [QAP] button at the bottom of the Worklist or Acquisition screen.
The Image Quality screen appears.
Figure A8-2 Image Quality screen
2. Select Quality Control Tests from the left side of the screen (Figure A8-3).
Figure A8-3 QAP selection from left side of screen
The Quality Assurance Program screen appears.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
