Chapter A2: General Information
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A2-6
Operator Manual © 2008 General Electric Company. All rights reserved.
4. Press [LOGIN].
The Worklist appears.
NOTE: If you have administrator access, a message appears: “You have both regular user and admin user
privileges. To access the admin screen, select the check box before continuing with the login,
otherwise just continue with the login.”
– To login and begin working with the unit, press [LOGON] and the Worklist appears.
– To login and access login administrator functions, select the Enter admin screen checkbox
and then press [LOGON]. The Login Administration screen appears. Refer to Appendix B: Log-
in Administration for more information.
Invalid Password Message
Your Password must be entered correctly for you to log in. If the password you entered is not the correct
password for the entered Login Name, an error message will appear.
1. Make sure that the correct Login Name is displayed in the field. Depending on the configuration, the
Login Name may be case sensitive. That is, “aBc” is not the same Login Name as “Abc.”
2. Retype your Password carefully. Your password is case sensitive; that is, “xYz” is not the same
password as “Xyz.”
3. Press [LOGON].
Contact your technical support group or system administrator if you still are not able to login.
Emergency Login
Emergency Login is a HIPAA required function to allow quick access to medical systems in the event of an
emergency. Depending on the system’s configuration, this option may not be available. Refer to
Appendix B: Login Administration
to configure the Emergency Login function.
Emergency Login will allow exposures, but does not allow connection to HIS/RIS or PACS hosts.
CAUTION: The Emergency Login function should NOT be used when there is time to login normally,
when there is time to receive assistance from technical support, or if there is no emergency
situation. Your facility may track the use of this function.
1. Press [EMERGENCY LOGON].
Depending on the system’s configuration, you may be prompted to enter your name. Enter your
name and press [LOGIN].
2. The Worklist screen appears.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
