Chapter A3: Worklist
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A3-11
Operator Manual © 2008 General Electric Company. All rights reserved.
Refresh
Some systems are configured to automatically refresh the Worklist with data from the HIS/RIS on a
regular basis (such as every 10 minutes). However, if your system does not automatically refresh—or you
want to refresh the list before the scheduled time—you are able to refresh the list manually.
For mobile units, Refresh only functions when the unit is connected to the network. If the unit is not
connected to the network, pressing the [REFRESH] button only displays the current Worklist data.
The Refresh feature also removes any filtering that has been applied. Refer to Filter List
(p. A3-8) for more
information.
Manual Refresh
Follow this process to manually refresh the Worklist.
1. Press [REFRESH] on the Worklist.
The Worklist updates with HIS/RIS data and removes any filtering.
NOTE: Refresh does not remove locally added procedures.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Auto Refresh
The Auto Refresh interval is set on the Preferences – Worklist screen in System Utilities. Refer to
Chapter A7: Set Preferences-Worklist
(p. A7-13) for more information.
When the system auto refreshes, a message (Figure A3-7) appears: “Auto Refresh in progress. Please
wait.” The message remains until the refresh process is complete.
NOTE: You will not be able to make selections or access Worklist functions while the Worklist is refreshing.
Figure A3-7 Auto refresh message
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
