Chapter A3: Worklist
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A3-10
Operator Manual © 2008 General Electric Company. All rights reserved.
5. If you selected Range for the Date option, enter or select the From and To dates.
The current date appears in both the From and To fields by default.
To select dates from the calendar:
a) Press the [CALENDAR] button.
Figure A3-5 Calendar button
– The Filter calendar screen appears with the current date selected.
Figure A3-6 Filter calendar screen
b) Press [
] to select the previous month, if necessary.
c) Press [
] to select the next month, if necessary.
d) Press a date to select it.
– The calendar closes automatically when a date is clicked.
6. Enter any Patient Information you want to filter by.
You do not need to enter full words or numbers into these text boxes.
Entering more information into these text boxes will reduce the number of results.
Entering less or no information into these text boxes will increase the number of results.
NOTE: The Patient Information text boxes are case sensitive.
7. Press [OK].
The Filter screen closes and the Worklist screen appears with only those procedures that met all of
the filtering criteria.
If no procedures met all the criteria, the Worklist will be blank.
8. Press [REFRESH] to remove the filter.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
