Chapter A2: General Information
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A2-11
Operator Manual © 2008 General Electric Company. All rights reserved.
Figure A2-10 Example of a System Status message
Message Log
Pressing the Message Log button at the bottom of any screen opens the Message Log (Figure A2-11). The
Message Log shows all status messages since the last system restart. The messages are listed in
descending chronological order, that is, the latest message is listed first. This screen allows operators
and service personnel to display, review, and analyze system status messages.
Figure A2-11 Message Log
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
