Chapter A1: Detector Overview
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A1-10
Operator Manual © 2008 General Electric Company. All rights reserved.
Cleaning
All exterior surfaces—detector, tether, and grid—should be cleaned after each exam.
• The detector and grid must be allowed to dry before use.
• Do not leave disposable wipes or cleaning cloths on the detector or grid for more than 60 seconds.
• Let the detector dry at least 60 seconds between cleanings.
The following chemicals and products have been tested and approved by GE for cleaning the GE Portable
DR Detector, grid, and tether.
•Cidex OPA
•Gigasept FF
•T-Spray
•Inciden Plus
• Perasafe
• Ster-Bac Blue
• Super Sani-Cloth Germicidal Wipes
• TriGene
• Isopropyl Alcohol (70% maximum solution)
•Bleach (50% solution)
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).