Chapter A7: Set Preferences
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A7-22
Operator Manual © 2008 General Electric Company. All rights reserved.
Auto Send (Auto Push)
Auto Send automatically transfers images to another network device when the exam is closed. Auto
Send is enabled and configured from the Utilities – Preferences screen.
For mobile units, Auto Send will begin the next time the unit is connected to the network.
Follow this process to configure Auto Send.
1. From the Worklist screen, press [UTILITIES].
2. Select Preferences > Image Management.
3. Click Auto Push [EDIT].
The Auto Send screen appears.
4. Complete the information as described in Table A7-8.
5. When finished, press [SAVE] to retain your changes.
Figure A7-15 Auto Send
Table A7-8 Auto Send Functions
[CANCEL] Closes the Auto Print screen without saving your changes.
Function Description
Auto Send
[ON] [OFF]
Turns Auto Send on or off.
Selecting On allows you to configure the default Auto Send settings.
Network Host column Lists the available network locations where images may be transferred.
Refer to Network Connections
(p. A7-2) for information about how to
configure the available Network Hosts.
Function Description
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
