Chapter A5: Image Viewer
Definium AMX 700 X-Ray System 5161515-1EN Rev. 6 (10 February 2008) A5-27
Operator Manual © 2008 General Electric Company. All rights reserved.
Send Images
If Auto Send is enabled, acquired images are automatically sent to a pre-determined location on exam
close. Refer to Chapter A7: Set Preferences-Auto Send (Auto Push)
(p. A7-22) for information on
configuring Auto Send.
For mobile units, Auto Send will begin the next time the unit is connected to the network.
Save Changes to Images
You have the option to save or discard the changes you have made to images when you close the Image
Viewer screen or end the exam.
1. If in a live exam, press [CLOSE] on the Acquisition screen.
2. If in review mode, press [CLOSE] on the Image Viewer screen.
A message appears: “Would you like to save the changes made to the images?”
3. Press [YES].
[NO] closes the Image Viewer screen without saving changes.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
